ServicesMetal Roofing
Metal Roofing in Meridian Hills
We install metal roofs on homes and we take care of the ones already up there. Most metal roof trouble starts small, at a screw, a seam or a flashing. We find it, fix it right and tell you plainly how many good years the panels have left.

A metal roof lasts a long time if the small parts get looked after
The panels are rarely the weak point. The parts that hold them down and seal them are. Rubber washers under exposed screws dry out and crack. Screws back out a little each time the metal heats up and cools down. Sealant at laps and around pipes shrinks and lets go. Fix those and the steel keeps doing its job.
Our cold winters and hot summers mean a lot of expansion and contraction, so these parts wear faster than people expect. That is why we put upkeep first. If your metal roof is sound, we keep it that way. If you are thinking about a new one, we install it so it is easy to maintain down the road.
What our metal roofing work covers
Standing seam installs
Concealed-fastener panels held by clips that let the metal move with temperature. No screws go through the face of the roof, so there are far fewer places for water to get in.
Exposed-fastener panel roofs
A lower-cost option where screws with sealing washers go through the panel. We set each screw snug, not crushed, so the washer seals without splitting.
Fastener service
We check screws across the roof, tighten loose ones and swap worn ones for new screws with fresh washers. Stripped holes get a slightly larger screw so it bites again.
Seams, flashing and penetrations
We reseal panel laps, ridge caps, and the flashing around chimneys, vents and skylights with sealant made for metal. Pipe boots that have cracked get replaced.
Finish and rust touch-up
Scratches and cut edges are where rust starts. We clean those spots and touch them up with matching coating before rust spreads under the paint.
Snow guards and trim
Metal sheds snow fast. Snow guards over doors, walkways and gutters keep it from coming off in one slab, and we check eave and rake trim while we are up there.

Signs your metal roof needs attention
- Screws sitting high
- If screw heads stand proud of the panel or the washers look gray and cracked, they are not sealing anymore. Water follows the screw shank into the deck.
- Rust at edges or laps
- Orange staining along panel ends, seams or around fasteners means the coating has broken down there. Caught early, it is a cleanup and touch-up job.
- Drips or stains inside
- A water spot on a ceiling or in the attic after rain usually traces back to a fastener, a lap or flashing. The leak often shows up a few feet from where it starts.
- Chalky, faded paint
- Rubbing the panel and getting color on your hand means the finish is wearing. It is not urgent, but it tells you the coating is thinning.
- Dents after a hailstorm
- Small dents may be cosmetic. Dents that crack the paint or bend a seam need a closer look, and they may be worth an insurance claim.
How a metal roof job runs
- 1
Free inspection
We get up on the roof and go over fasteners, seams, flashing and the finish. If there is attic access, we check the underside too. Everything we spot is photographed so you can see it for yourself.
- 2
A straight answer
We tell you whether the roof needs upkeep, repair or replacement, and why. Most of the time a sound metal roof just needs its small parts renewed.
- 3
Written estimate
Every item is listed with what we will do and what it costs, so nothing shows up later that you did not see first.
- 4
The work day
We protect plants and walkways, keep panels and scrap off your lawn, and work in sections so the roof is never left open. Metal shavings from cuts get swept up because they rust and stain.
- 5
Final walk-through
We go over the finished work with you and point out anything worth checking again in a year or two.
What sets the price of metal roofing
Upkeep on an existing metal roof usually costs a small part of what a new roof does. For new installs, the panel system and the roof itself drive most of the price. We spell out each piece in your estimate.
- Panel type
- Standing seam costs more than exposed-fastener panels because of the clips, the panel profile and the extra labor. It also needs less upkeep over its life.
- Roof shape and pitch
- Valleys, dormers, hips and steep slopes mean more cuts, more trim and slower work. A simple gable roof goes quickest.
- What is underneath
- If old shingles come off or soft decking shows up, that adds labor and material. We check the deck before giving you a number.
- Flashing and add-ons
- Chimneys, skylights, snow guards and new gutters all add to the job. Some are optional, and we tell you which.
- Scope of repair
- A few screws and a reseal is a short visit. Replacing fasteners across the whole roof, or coating work, takes longer. We also offer financing for larger jobs.
What people ask about metal roofs
- Will rain sound louder on a metal roof?
- Not much, if it goes over solid decking with underlayment. Most people notice about the same sound they had with shingles. The drumming you picture comes from bare metal over open rafters, like a pole barn. We always install over a full deck.
- Can metal go right over my old shingles?
- It can work when there is a single layer and the deck underneath is solid. We usually advise a tear-off so we can see the decking and fix any soft spots first. You hear what we find before you make the call.
- How much upkeep does a metal roof need?
- Some, but not a lot. Have it checked every few years for loose or worn screws, tired sealant at seams and flashing, and scratches in the finish. Small fixes like those are what let a metal roof last for decades. The roof inspections page goes through what we check.
- What does hail do to a metal roof?
- Usually it leaves dents that look bad but do not leak. Big hail can crack the paint or kink a seam, and that needs attention. We work with homeowners and insurance companies on storm damage claims, and we can show you what our photos support.
- Metal or shingles, which makes more sense?
- Metal costs more at the start and lasts longer with less upkeep. Shingles cost less and are easier to patch. The shingle roofing and roof replacement pages cover both, and during the inspection we will say which suits your home and budget.
- Will my gutters need replacing with a metal roof?
- Not in every case. Water and snow slide off metal faster, so gutters have to be well fastened and big enough to keep up. We look at them on every job, and our gutters page explains what we put up.
Get your metal roof looked over
We will check the screws, seams and flashing and tell you what needs doing now and what can wait. The inspection costs you nothing.